Acteon Mini LED - Disinfection and sterilising; Clean and disinfect the medical device; Cleaning, disinfecting and sterilising accessories

8 Disinfection and sterilising
The instructions relating to cleaning, disinfection and sterilisation protocols for accessories provided by SATELEC, a
company of Acteon Group have been approved for each medical device and accessory. The applicable guides are
listed in the chapter Associated documentation page 5.
They can be downloaded at the following address: www.satelec.com/documents.
In all cases, the local regulations in force relating to the cleaning, disinfection and sterilisation protocols for
accessories take precedence over the information provided by SATELEC, a company of Acteon Group.
8.1 Clean and disinfect the medical device
The Mini LED must be OFF during cleaning and disinfecting procedures. It must also be disconnected from its electricity
supply.
Avoid using cleaning and disinfection products that contain flammable agents. Otherwise, ensure that the product has
completely evaporated or that there is no fuel left on the medical device and its accessories before switching it on.
Do not use an abrasive product to clean the medical device.
Never apply sprays directly to the medical device to clean it. Always spray the product onto a wipe, then clean
the medical device.
Use alcohol disinfectant wipes.
l Unplug the power cord from the base.
l Remove the rigid protection shield.
l Remove the optical guide.
l Block the Mini LED handpiece nosepiece with a protection plug.
l Clean the body of the Mini LED handpiece with an alcohol wipe.
l Clean the Mini LED base with an alcohol wipe.
l Clean the rigid protection shield as indicated in the instructions in the chapter Associated documentation page 5
l Clean and sterilise the optical guide as indicated in the instructions in the chapter Associated documentation
page 5
8.2 Cleaning, disinfecting and sterilising accessories
The Mini LED accessories include:
l a charging base;
l an optical guide;
l a rigid protection shield.
The optical guide must be cleaned and sterilised prior to use. The rigid protection shield must be cleaned and
disinfected prior to use.
User Manual | Mini LED™ | J02541|V8|(07)| 01/2017|NG13EN010H - Page 21/38