Actron CP9580 - Powering the Scan Tool

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 5
Using The Scan Tool
3
Power
Internal Battery
✓ Battery power is not required to use tool.
✓ ON/OFF button on Scan Tool turns tool on and off.
❒ Press and hold ON/OFF key for at least 1 second to turn on
Scan Tool.
✓ The Scan Tool will automatically turn OFF after a user-selectable
period of inactivity when powered from the internal batteries.
✓ When powered from the internal batteries, the Scan Tool turns off
the backlighting for the display if no key presses are made during
a 1-minute period.
✓ If a key is pressed prior to the Scan Tool powering off, the
backlighting for the display will turn back on.
✓ The Scan Tool must be attached to the vehicle to perform
diagnostic functions. The Scan Tool disables the diagnostic
functions when powered from the internal batteries.
✓ Each time the Scan Tool is
powered up, voltage of the
internal battery is checked.
❒ If voltage is low, the Low
Battery Symbol (
Z )
displays on screen.
❒ Replace the battery using
instructions provided in
Battery Replacement.
If the Scan Tool will not be used for an extended
period of time, remove the batteries to prevent
battery leakage from damaging the battery
compartment.
=====================
Vehicle Diagnostics
Review Data
Print Data
System Setup
Main Menu
Vehicle Diagnostics
Z
!
CAUTION