100S Reference Manual
27
Recommended
Corrective Action
Decimal point
scrolls across
display
Press any key or move the
table to return to the previ-
ous screen.
System has been idle
for approximately 90
minutes and is in
“display saver”
mode
Symptom
Probable Cause
Screen is
blank
Check that the power
switch on the back of the
console is “on.”
No power to the
readout
Check that the readout’s
power cord is properly
connected to the power
supply.
Check that the power
source meets the specifica-
tions required by your
system (pg. 33).
Contact your
100S distrib-
utor for repair/
replacement procedures.
LED failure
Dashes
appear on
screen
The value entered exceeds
the display’s 8-character
capability. Enter a value
with less than 8
characters.
(cont’d next page)
Display overflow
Check the fuse. (Located
above the power switch).
TROUBLESHOOTING
To Next Page
Loading...