28
TROUBLESHOOTING
100S Reference Manual
Keys not
working
properly
Error mes-
sages (E2-
E58) appear
Causes vary
Invalid keypress
Symptom
Recommended
Corrective Action
Probable Cause
Turn the system “off”
and then “on” again,
using the switch on the
back of the readout.
If an error (besides E1)
is still detected when the
system is powered up,
contact your 100S dis-
tributor for
repair/replacement
procedures. Refer to pgs.
31 - 32 for a list of error
messages.
Dashes
appear on
screen
(cont’d)
Move the table toward
the “0” position. As the
scale counts down, the
display will show the
correct position.
Display overflow
Turn the system “off” and
then “on” again, using the
switch on the back of the
readout. If an error
(besides E1) is still detect-
ed when the system is
powered up, contact your
100S distributor for
repair/replacement proce-
dures. Refer to pg. 31- 32
for a list of error messages.
Error mes-
sage (E1)
appears
Power loss occurred
This is a normal mes-
sage at power up. If the
message appears at any
other time during opera-
tion, a problem may
have occurred. Refer to
pg. 31 for details.
To Next Page
Loading...