© Adam Equipment Company 2004
8
4.3 WEIGHING
After zeroing the display and taring the container, place the
sample in the container to determine the weight of the
sample. The weight will also be displayed through a bar-
graph at the bottom of the LCD.
The display will show the weight and the units of weight
currently in use. The stable indicator
will be on. To
change the weighing units, press [Mode] to cycle through the
options of units those are enabled. See the Parameter
section to enable or disable the weighing units.
The accumulated value in the memory will be cleared when a
new weighing unit or during recalling the memory, %
weighing or parts counting is selected.
4.4 PERCENT WEIGHING
The scale will allow a sample weight to be shown as 100%.
Then any other weight placed on the scale will be displayed
as a percentage of the original sample.
For example is 350g is placed on the scale and the [%] key
is pressed the display will show 100.00%. Removing the
350g weight and place a 300g weight on the scale. The
display will show 85.71% as 300g is 85.71% of 350g.
Note: The scale may jump by large numbers unexpectedly if
small weights are used to set the 100% level. For example, if
only 23.5g is on a scale with 0.5g increments and the scale is
set to 100%, the display will show 100.00%. However, a
small change of weight will cause the display to jump to
102.13%, as one scale division (0.5g) increase to 24.0g will
be equivalent to a 2.13% increase.
Pressing the [%] key again will return the scale to normal
weighing.
To Next Page
Loading...
