© Adam Equipment Company 2004
9
4.5 PARTS COUNTING
When the scale is in normal weighing mode, pressing the
[Smpl] key will start the parts counting function.
Before beginning, tare the weight of any container that will be
used, leaving the empty container on the scale.
Place the number of samples on the scale. The number
should match the options for parts counting, 10, 20, 50, 100
or 200 pieces.
Press the [Smpl] key.
The scale will initially show "SP10" asking for a sample size of
10 parts. Press [Mode] to cycle through the options: 10, 20,
50, 100, 200 and back to 10.
Press [Smpl] again when the number matches the number
of parts used for the sample. As more weight is added the
display will show the number of parts (PCS) with respect to the
chosen sample size.
Press [Mode] to display unit weight (W/P), total weight (g) or
the count (PCS). The total and the unit weight are shown in the
current units.
Press [Smpl] to return to normal weighing.
4.6 ACCUMULATION
When the scale is set for automatic accumulation, the weight
will be added to the memory when the scale becomes stable.
The scale must return to zero before another weight is
added.
When the scale is set to manual accumulation (See the
Parameter Section) the weight displayed will be stored in
memory when the [Print] key is pressed and the weight is
stable.
The display will show "ACC 1" followed by the total value in
the memory for 2 seconds before returning to displaying the
weight of the item on the scale.
To Next Page
Loading...
