© Adam Equipment Company 2004
15
5.3.4 Parity settings
The current Parity setting will be displayed.
Press [Mode] to cycle through the other options.
The following settings are available:
8 n 1
8 data bits, no parity
7 E 1
7 data bits, even parity
7 0 1
7 data bits, odd parity
Press [Zero], the display will go back showing “F3 SEr”.
Press [Mode] to go to the next parameter which is “F4 oFF”.
5.4 SETTING OF AUTO-SWITCH-OFF
The Auto switch-off time may be set up by the user.
When “F4oFF” is displayed, press the [Zero] key to view the
current setting for the backlight.
Press [Mode] to scroll through other settings (0, 5, 10, 20
and 30 minutes).
Press [Zero] to store a particular setting.
Use the [Print] key to leave a parameter unchanged.
5.5 TECHNICAL PARAMETERS
Next parameter is “tECH”. This allows the user to enter the
Technical Parameters section.
Press [Print] to return to weighing. The scale will run the
self-test before displaying the zero along with the last
selected unit.
Note: It is recommended not to proceed with the settings of the Technical
Parameters which are set up at the factory and are often referred to as Service
Parameters. Check the Service Manuals for more details.
To Next Page
Loading...
