Jumper Location and Access
The configuration jumpers are located on the D-SERV card. Plug-in
units have the jumpers readily accessible.
To access the jumpers on a stand-alone unit:
¤ Disconnect all power connections and interface cables
¤ Turn the D-SERV unit over, and using a phillips
screwdriver remove the four screws connecting the two
sides of the case (see Figure 13 for location of screws)
¤ Separate the case
¤ Set the jumper(s)
¤ Close the case and secure with the four screws
Figure 12. Configuration Jumper Location
Operator's Manual
20
To Next Page
Loading...
Need help?
General