Mounting
NOTE: It will be necessary to set the configuration of the
D-SERV DSU/CSU before mounting the unit. Refer to
Section 2, Configuration
for complete configuration
information.
There are four ways to mount the D-SERV DSU/CSU:
¤ Desktop mounting (on any flat surface)
¤ Vertically, on a wall using model #78035 Wall Mount
Brackets
¤ Side by side in a 19" or 23" equipment rack using model
#78255 Mounting Tray
¤ Where space is critical, up to 12 D-SERV units can be
mounted in a 19" or 23" equipment rack using the model
#78260 High Density Mounting Chassis
NOTE: Refer to the Installation Instructions accompanying the
Wall Mount Brackets, the Mounting Tray or the High
Density Mounting Chassis for details on their
installation.
Desktop Mounting
Any clean level surface can be a platform for the D-SERV unit.
Operator's Manual
27
To Next Page
Loading...
Need help?
General