ACCEPTABLE
CORRECT
CG markes
UNACCEPTABLE
CG marks
Connect the battery connector to the FC
power connector and place the device on
a level place. Close the battery cover
Wait 1 minute until calibration is completed
and the system initializes.
Check the connection with the remote
control by moving the roll/pitch handle.
Do not remove the plug from the pitot
tube!
Check that all controls on the remote
control are in their original positions.
Turn on the control panel by long
pressing the POWER button.
Turn on the FPV goggles; to do this,
connect the battery cable to the
socket.
ATTENTION! Checking the location of the center of gravity is
a critical step in pre-flight preparation.
If the CG is too rearward (the plane is tilted back when hanging)/
this will lead to uncontrollability and loss of the plane!
A slight forward CG is allowed
(the airplane is tilted slightly forward when hovering).
Check the location of
the center of gravity (CG
):
To do this, you need to place your
index fingers on special marks on the
bottom of the wing and hang the
plane horizontally.
25
Pre-flight preparation 2
To Next Page