ATTENTION!
Always perform the DISARM procedure before handling the aircraft to
prevent the engines from starting unintentionally and causing injury.
ATTENTION!
If the GPS signal is lost, the LOITER and QRTL modes will not work
correctly or will be unavailable. It is prohibited to use them in
conditions of GPS suppression.
The flight along the route is carried out as standard for airplanes. If there is a
GPS signal, the current coordinates will be displayed on the OSD, in
addition, the arrow will point to the starting point.
Cruising flight speed: 65-75 km/h. At this speed there will be
minimal battery consumption.
If GPS is unavailable, orientation must be performed visually. Speed will be
displayed based on the airspeed sensor, and altitude based on the built-in
barometer.
If the GPS signal is normal, you can use automatic return to the starting point
by turning on the QRTL mode. To do this, you need to turn the QRTL toggle
switch all the way up. The mode works in any position of the mode switch.
In case of loss of communication with the remote control (FAILSAFE), the
QRTL mode will also automatically turn on.
When turned on, if the plane is far enough from the starting point, it will
automatically enter airplane mode and begin to move. When approaching, at
a certain distance, it will automatically switch to copter mode, perform
braking, then hover over the take-off point and begin to descend.
After touching the ground, it will turn off the engines. It is recommended to
always force DISARM.
In FWBA mode, the aircraft has angle restrictions: roll +-35 degrees, pitch
+25-20 degrees. During flight, you can rotate the camera horizontally and tilt
it vertically.
If you need to inspect a specific area of the terrain, you can use the LOITER
mode.
To do this, you need to move the SC mode switch to the bottom
position (on oneself). The plane will begin a circular motion with a right bank
around the point and a radius of 120 meters where this mode was turned on.
When LOITER is turned on, the aircraft is automatically controlled in roll,
throttle and pitch. At this time, you can only control the camera's tilt and pan.
To exit the mode, you must switch the mode switch to FWBA or QHOVER
mode.
Flight
28
To Next Page