Materials and accessories for assembly:
FDM filament:
АBS High Tech Plast/PLA+ Esun
1.
Glue:
the model is assembled without glue
2.
Wires:
16,24 and 28 AWG
3.
Connectors:
XT60 1 pcs ХТ30 1 pcs (option)
4.
Servo extensions:
200 mm 6 pcs
5.
Carbon:
square profile 6x6x500 mm 3 pcs
6.
Pushing rod:
steel wire
1,2 mm or ready-made rods L=200mm
7.
Plastic ends
for rods 1,2 mm 4 pcs
8.
Strap
for battery 250 mm 1 pc9.
Nylon ties
2 mm
10.
Hardware
:11.
Brass stands M2x12 4 pcs (only for SpeedyBeeF405Wing FC)
Round head self-tapping screws DIN 7981:
2,2x4,5- 2 pcs
2,2x6,5- 5 pcs.
2,2x9,5- 32 pcs
2,2x16- 16 pcs
Screws DIN 7045:
M2x8 - 29 pcs
M2x16 - 16 pcs
Hex Bolts DIN 933:
M3x16 3 pcs
M5x25 1 pcs
Lock nuts DIN 985:
M3 - 3 pcs
M5 - 1 pcs
Security measures:
Work with glue and activator in a well-ventilated area.
1.
Do not leave parts or the assembled aircraft in direct sunlight or in
2.
rooms with temperatures above 40 degrees for a long time without
cooling.
Observe polarity
when connecting power sources and various
3.
equipment.
Be sure to remove the propellers whenever checking the motors on
4.
the ground to avoid serious injury.
During the assembly:
Before connecting, try to connect the parts “dry”. If there are burrs
1.
and irregularities, cut them off with a sharp knife.
To make pushing the axle easier, it is recommended to use a small
2.
amount of silicone grease.
When assembling the suspension, be careful and attentive: the
3.
rockers on the servos must be installed in such a way that in the
extreme positions the parts of the suspension do not damage the
gearbox. All gimbal and elevon control channels must be set to
neutral (1500 µs). Accurately set the neutral position of the gimbal
using the autopilot configurator.
3
Assembly recommendations
To Next Page