ADJ KAOS - System Menu: Operation Modes; Show Mode; Sound State; DMX Last State

ADJ Products, LLC - www.adj.com - KAOS User Manual Page 12 ADJ Products, LLC - www.adj.com - KAOS User Manual Page 13
Show Mode - Show modes 0-15 (Factory programs).
Show mode can run with or without sound active mode.
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show XX” will now be displayed, “XX” representing a number
between 0-15. Programs 1-15 are factory programs, while “Show
0” is random mode. Press the UP or DOWN buttons to nd your
desired show.
3. When you have found your desired show press ENTER, then
press and hold the MENU button for at least 3 seconds to acti-
vate.
Sound State - Sound Active mode.
1. Press the MENU button until “Sound State” is displayed,
press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to activate sound active mode,
or “OFF” to deactivate sound active mode.
3. Press ENTER, and then press and hold the MENU button for
at least 3 seconds to activate.
Sound Sense - Sound sensitivity control.
1. Press the MENU button until “Sound Sense” is displayed, press
ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sen-
sitive and 100 the most sensitive.
3. Press the ENTER button to conrm.
DMX Last State - This mode can be used as a precau-
tion mode, that in case the DMX signal is lost, the operating
mode chosen in this setup is the running mode the xture
KAOS System Menu
will go into when the DMX signal is lost. You can also set
this as the operating mode you would like the unit to return
to when power is applied.
1. Press the MENU button until “DMX Last State” is displayed,
press ENTER.
2. Either “Master/Slave” or “Last State” will be displayed.
Choose an operating mode you would like the unit to start up in
when power is applied or the DMX signal is lost.
• Master/Slave - If the DMX signal the the unit will automatically
go into Master Slave mode. If this setting is chosen and power
is lost, this is the setting that the unit will start up in when power
is applied.
• Last State - If the DMX signal is lost the xture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to conrm your desired set up
Dimmer Curve - In this mode you can select the
dimmer curve.
1. Press the MENU button until “Dimmer Curve” is displayed,
press ENTER.
2. 1 of 5 dimmer curves will be displayed.
3. Press the UP or DOWN buttons to nd your desired dimmer
curve and press ENTER to conrm. Please see the dimmer curve
chart on page for more information.
Pan Invert - This function activates pan inversion.
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER.
2. The display will show either “Normal” or “Invert”. Press the
UP or DOWN buttons to select “Invert” to activate pan inver-
KAOS System Menu