ADJ POCKET PRO - System Menu Details; DMX Address Setting; Channel Mode Selection; Primary;Secondary Mode Setup

ADJ Products, LLC - www.adj.com - Pocket Pro User Manual Page 12
System Menu: When making adjustments press ENTER to conrm your setup then press and
hold the MENU button for at least 3 seconds. To exit without making any adjustments press
the MENU button. The display will lock after 30 seconds, press the MENU button for 3 seconds
to unlock.
DMX Address - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until “DMX Address” is displayed, press
ENTER.
2. The current address will now be displayed and ashing. Press the UP or DOWN buttons to nd
your desired address. Press ENTER to set your desired DMX address.
Channel Mode - This will let select your desired DMX channel mode.
1. Press the either the MENU button until “Channel Mode” is displayed, press ENTER. Either
“11Chan” or “13Chan” will be displayed
2. Press the UP or DOWN buttons to nd your desired DMX channel mode and press ENTER to
conm and exit.
Pri/Sec Mode - This will let you set unit as a primary or secondary in a primary/secondary con-
guration.
1. Press the MENU button until “Pri/Sec” is displayed, press ENTER. Either “Pri”, “Sec 1”, or “Sec 2”
will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, press ENTER to conm.
NOTE: In a Primary/Secondary conguration you can set one xture to Primary and then set the
next xture to “Sec. 2”, the xtures will now have contrast movement to each other.
Show Mode - Show modes 0-4 (Factory programs). Show mode can run with or without sound
active mode active.
1. Press the MENU button until “Show Mode” is displayed, press ENTER.
2. “Show X” will now be displayed, “X” representing a number between 0-4. Shows 1-4 are factory
programs, while show “0” is random mode. Use the UP or DOWN buttons to nd your desired
show.
3. When you have found your desired show press ENTER, then press and hold the MENU button for
at least 3 seconds to activate. After you have set your desired show, it can be changed at any
time using the UP or DOWN buttons.
Target Mode - Target mode is a restrictive pan/tilt control limiting the movement to a certain
degree.
1. Press the MENU button until “Target Mode” is displayed, press ENTER. One of 5 target modes will
be displayed. Note: Target Mode will only work with Shows 3 & 4.
• Mode 1 - 0° - 180°
• Mode 2 - 90° - 270°
• Mode 3 - 180° - 360°
• Mode 4 - 270° - 540°
• Mode 0 - Random Mode
2. Press the UP or DOWN buttons to nd your desired Target mode.
3. Press ENTER to conrm.
Pocket Pro System Menu