ADJ Vision Series - General Information; Introduction to Vision Series Panels; Unpacking and Initial Checks

4
INTRODUCTION
Please read and understand the instructions in this manual carefully and thoroughly before attempting
to operate this device. These instructions contain important safety and use information.
ADJ’s Vision Series LED Video Panels oer the highest quality LED binning using 3-in-1 RGB SMD2121
LEDs, with a brightness of 1000 NITS. The primary dierence between models is the pixel pitch: the
VS2 has a pixel pitch of 2.97mm, the VS3 has a pixel pitch of 3.91mm, and the VS5 has a pixel pitch
of 5.95mm. All models have 4 individual modules for quick and easy front and rear accessible servic-
ing; are built on the same frame, allowing panels with dierent resolutions to be used together; use the
same rigging bar; all t into the same road case; and all have moveable integrated Corner Protectors
that safe-guard the corners when they are not connected. In addition, each Vision Series LED Video
Panel model has magnets located at the top and bottom to allow a user to temporarily connect two
panels, release his or her grip, and then securely latch them on the rear. This allows a single user to
install a full wall of panels.
The Vision Series LED Video Panel connections include Power In/Out and Data In/Out, and feature
built-in Novastar A5s receiving card. An optional VSFC8 Flight Case (purchased separately) can carry
up to 8x VS LED Video Panels, and an optional VSRB1 Rigging Bar (purchased separately) can hang
up to 20 VS LED Video Panels vertically.
ADJ oers full packages with video processors, software, cabling, rigging bars, and ight cases so
that you have everything you need to get up and running.
UNPACKING
Every Vision Series LED Video Panel has been thoroughly tested and has been shipped in perfect
operating condition. Carefully check the shipping carton for damage that may have occurred during
shipping. I the carton is damaged, carefully inspect the device for damage, and be sure all accessories
necessary to install and operate the device have arrived intact. In the event that damage has been
found or parts are missing, please contact our customer support team for further instructions. Please
do not return this device to your dealer without rst contacting customer support. Please do not dis-
card the shipping carton in the trash. Please recycle whenever possible.
GENERAL INFORMATION