ADJ Vision Series - Operational Safety Practices

8
SAFETY GUIDELINES
• DO NOT touch panel housing during operation. Turn OFF power and allow approximately 15 min-
utes for panel to cool down before servicing.
• DO NOT operate devices with covers open and/or removed.
• DO NOT shake panel, and avoid brute force when installing and/or operating.
• DO NOT expose any part of the panel to open ame or smoke. Keep panel away from heat
sources such as radiators, heat registers, stoves, or other appliances (including ampliers) that
produce heat.
• DO NOT install/use in extremely hot/humid environments, or handle without ESD precautions.
• DO NOT exceed an operation temperature of 40°C (104°F), as doing so will result in damage to
the device.
• DO NOT operate if power cord is frayed, crimped, damaged, and/or if any of the power cord
connectors are damaged and do not insert into the panel securely and with ease. NEVER force
a power cord connector into the panel. If the power cord or any of its connectors are damaged,
replace immediately with a new cord and/or connector of the same power rating.
• DO NOT block air ventilation slots/vents. All fan and air inlets must remain clean and never
blocked.
• Allow approximately 6” (15cm) between panel and other devices or a wall for proper cooling.
• ALWAYS disconnect panel from main power source before performing any type of service and/or
cleaning procedure.
• Only handle the power cord by the plug end, and never pull out the plug by tugging the wire por-
tion of the cord.
• ONLY use the original packaging materials and/or case to transport the panel in for service.
• PLEASE recycle shipping boxes and packaging whenever possible.
• To avoid causing physical damage, read the installation instructions carefully before installation.
• Panels should be installed/operated by qualied and trained professionals ONLY.
• Always mount panels in a safe and stable manner.
• INDOOR / DRY location use ONLY! Outdoor use will void the manufacturer’s warranty.
• Wear appropriate safety equipment during panel installation.
• Turn OFF power to panel, computers, servers, system boxes, and monitors before making any
type of power or data connections and before performing any maintenance work.
• Electronics used in this panel are ESD (Electrostatic Discharge) sensitive. To protect device from
ESD, wear a grounded ESD wrist strap or similar grounding device when handling panel.
• Panel must be properly grounded before operating. (resistance must be less than 4Ω)
• Ensure all power is disconnected from panel before unplugging any data cables from the panel,
especially serial line ports.
• Route power and data cables so that they are NOT likely to be walked on or pinched.
• Air conditioning is required if operating environment temperature exceeds 30°C (86°F).
• If panels are not in regular use for an extended period, it is advised to test run the devices for 2
hours each week to ensure that they remain in proper working condition.
• Cases used to transport panel must me properly waterproofed for transportation.