ADTRAN Total Access 600R - Setting up Routing Options

64200600L1#T-31A © 2002, ADTRAN, Inc. Page 67
Total Access 600R User Interface Guide (UIG)
Setting up Routing Options
The Total Access 600R can support IP routing and bridging.These procedures are described on the pages that follow.
IP Routing
There are three steps required for the Total Access 600R to be used for IP Routing: (1) Global IP Setup, (2) Ethernet
IP Setup, and (3) WAN IP Setup. All of these procedures are described in the pages that follow.
Global IP Setup
For basic IP routing, use all of the default values from the
G
LOBAL
configuration menu.
Global IP Setup Instructions
Step Action
1
From the Main Menu, select
R
OUTER
, select
C
ONFIG
, and then select
G
LOBAL
.
2 Press Enter on the IP [+] option.
3
Set the
M
ODE
to
O
N
.
4
Press Enter on the S
TATIC
R
OUTES
[+] to place static routes in the rout-
ing table.
5
Press Enter on DHCP S
ERVER
[+] if the Total Access 600R needs to
serve IP addresses to Ethernet devices.
6 Set the DHCP M
ODE
to O
N
. It is O
FF
by default.
7
To place DNS information in the Total Access 600R, press Enter on
DNS [+]. Enter Server IP addresses in the server fields.