ADTRAN Total Access 600R User Manual

Page 68 © 2002, ADTRAN, Inc. 64200600L1#T-31A
Total Access 600R User Interface Guide (UIG)
Ethernet IP Setup
Ethernet IP Setup Instructions
Step Action
1
From the Main Menu, select R
OUTER
, select C
ONFIG
, and then select
E
THERNET
.
2
Press
Enter
on the
P
RIMARY
IP [+]
option to enter primary ethernet con-
figuration.
3 Set the IP ADDRESS of the Ethernet port.
4 Set the S
UBNET
M
ASK
of the Ethernet port.
5 Set the D
EFAULT
G
ATEWAY
of the Ethernet port if needed.
6
RIP
on the Ethernet is disabled by default. If
RIP
needs to be enabled,
press Enter on RIP [+]
7 Press the left arrow key to return to the main Ethernet menu.
8
If the Total Access 600R needs additional secondary IP addresses,
press
Enter
on
S
ECONDARY
IPS
[+].The Total Access 600R supports up
to 10 additional LAN segments.
Enter each additional secondary IP address and subnet mask. Press "I"
to insert additional entries.

ADTRAN Total Access 600R Specifications

General

Brand	ADTRAN
Model	Total Access 600R
Category	Network Router
Language	English