64200600L1#T-31A © 2002, ADTRAN, Inc. Page 69
Total Access 600R User Interface Guide (UIG)
WAN IP Setup
For WAN IP setup, choose either PPP IP Setup or Frame Relay IP Setup. Both of these procedures are described on
the pages that follow.
WAN IP Setup - PPP IP Setup Instructions
Step Action
1
From the Main Menu, select R
OUTER
, select C
ONFIG
, and then select
WAN
.
2
Set the
L2 P
ROTOCOL
to
PPP.
3 Press Enter on the PPP P
ROFILE [+] option.
4
Press
Enter
on the
A
UTHENTICATION
[+]
option if you wish to change
options related to how the link is established. Default is T
X
M
ETHOD
=
PAP, CHAP,
OR
EAP.
5
Press the left arrow key to return to the WAN/PPP P
ROFILE
menu, and
then press
Enter
on the
IP [+]
option. Verify that
M
ODE
is
O
N
6 Arrow down to R
OUTE
[+] to enter WAN IP information.
7
Enter WAN information:
• Far-End IP Address The far-end WAN IP address from the
Total Access 600R.
• Subnet Mask The subnet mask for this WAN link
• Local IP The local WAN IP address for the Total
Access 600R.
The other config items can be left at the defaults.
8
Use the <Esc> key to return to the top level Total Access 600R menu.
Confirm any necessary changes.
9 For NAT configuration, please see IP Routing with NAT.
To Next Page
Loading...
