27
10.2a Aux Meter Review
A review screen of the current settings is provided with a selection for the Tracking method and the
Settings.
SETTINGS
meter.
TRACKING - Provides a pop-up screen to select
either FloTracker or Rate and Volume tracking.
NOTE: Select FloTracker if the aux meter is a
FloTracker. Select Rate and Volume if tracking a
10.2b Aux Meter Settings
PULSE VALUE
contact, i.e. 225.
UNITS
i.e. Pulses / Ounce.
RESET TOTAL - Resets the totalized count of the
meter.
VERIFY ALARM
the relay is not on.
RELAY LINK - The relay link informs the particular aux meter input is relevant to the control function that the
should be linked to the relay that is driven by the feed timer that pump will be controlled by. If the aux meter
is going to be linked to a water meter in a bleed of line, then it should be linked to the relay that is controlling
VOLUME ALARM - If FloTracker has been selected as the Tracking method, an alarm will occur when the
Note:
RESET VOLUME - Resets the Volume Alarm totalizer.
METER LINK – This selection only shows if the tracking method is Rate and Volume and tells the auxiliary
>FLOW METER 1<
TOTAL VALUE: 9966.0 ML
FLOW RATE: 0.0 ML/MIN
CONTACT VALUE: 0.33 ML/CONTACT
LAST RESET ON: 08/25/2006
VOLUME ALARM: 1000 LITERS (24 HOURS)
ALARM NOTIFY: (DISPLAY)
VOLUME: 0.0 LITERS
VERIFY ALARM: 100 SEC (DISPLAY)
RELAY LINK: SYS1 TIMER3
SETTINGS TRACKING
>FLOW METER 1 SETUP<
PULSE VALUE VOLUME ALARM
UNITS RESET VOLUME
RESET TOTAL
VERIFY ALARM
RELAY LINK METER LINK
To Next Page
