Advantech Adam-4016 - Page 96

Command Set
4-12 ADAM 4000 Series User's Manual
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration Set the address, input range, baud
rate, data format, checksum status
and/or integration time for the
specified analog input module
444
#AA Read Analog Input Return the input value from the
specified analog input module in the
currently configured data format
452
$AA0 Span Calibration Calibrate an analog input module to
correct for gain errors
457
$AA1 Offset Calibration Calibrate an analog input module to
correct for offset errors
458
$AA2 Configuration
Status
Return the configuration parameters
for the specified analog input module
448
#** Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers
459
$AA4 Read Synchronized
Data
Returns the value that was stored in
the specified module’s register after
the #** command
460
$AAF Read Firmware
Version
Return the firmware version code
from the specified analog input
module
450
$AAM Read Module Name Return the module name from the
specified analog input module
451
ADAM-4016 Command Table
(continued on following page)