Advantech Adam - 4051 - Table 4.4: ADAM-4013 Command Table; Table 4.5: ADAM-4015;ADAM-4015 T Command Table

ADAM-4000 Series User Manual 92
Table 4.4: ADAM-4013 Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration
Sets the address, input range, baud
rate, data format, checksum status,
and/or integration time for a specified
analog input module
5-4
#AA Analog Data In
Returns the input value from a speci-
fied analog input module in the cur-
rently configured data format
5-14
$AA0 Span Calibration
Calibrates an analog input module to
correct for gain errors
5-19
$AA1 Offset Calibration
Calibrates an analog input module to
correct for offset errors
5-20
#**
Synchronized
Sampling
Orders all analog input modules to
sample their input values and store
them in special registers
5-21
$AA4
Read Synchronized
Data
Returns the value that was stored in
the specified module's register after
the #** command
5-22
$AA2 Configuration Status
Returns the configuration parameters
for the specified analog input module
5-10
$AAF
Read Firmware
Version
Return the firmware version code
from the specified analog input mod-
ule
5-12
$AAM Read Module Name
Return the module name from the
specified analog input module
5-13
Table 4.5: ADAM-4015/ADAM-4015T Command Table
Command Syntax Command Name Command Description Page No.
%AANNTTCCFF Configuration
Sets the address, input range, baud
rate, data format, checksum status,
and/or integration time for a specified
analog input module
5-4
$AA2 Configuration Status
Returns the configuration parame-
ters for the specified analog input
module
5-10
$AAF
Read Firmware
Version
Return the firmware version code
from the specified analog input mod-
ule
5-12
$AAM Read Module Name
Return the module name from the
specified analog input module
5-13
#AA Analog Data In
Returns the input value from a speci-
fied analog input module in the cur-
rently configured data format
5-14
#AAN
Read Analog Input
from Channel N
Returns the input value from a speci-
fied channel of analog input module
in the currently configured data for-
mat
5-16
$AA5VV
Enable/Disable
Channels for Multi-
plexing
Enable or disable the individual chan-
nels in an analog module
5-17