Advantech ADAM-5510/P31 User Manual

ADAM-5510/P31 0-9
Chapter 0
0.3.3 Reboot ADAM-5510/P31
After I/O module configuration, you have to exit the ADAM utility and
then run “ADAM5510.exe” again.
1. Select the correct COM port.
2. Move the cursor to “Terminal” and press <Enter>.
3. Press the “RESET” button on the ADAM-5510/P31 front panel.
4. After ADAM-5510/P31 resets and reboots, the welcome screen
shown in Figure 0-4 will appear. Now you can operate the ADAM-
5510/P31 remotely through Advantech Paradym-31 on your host
PC.
Figure 0-4: Opening screen; operating ADAM-5510/P31 remotely

Advantech ADAM-5510/P31 Specifications

General

Brand	Advantech
Model	ADAM-5510/P31
Category	Controller
Language	English