Advantech EKI-6233BN - Mctrl; Mdata; Net

EKI-6233BN User Manual 63
Value 0 : None Setting.
Usage: mvcom [nn|all] bychar [NULL|]
Set datapackage as character(HEX).
Value 0 : None Setting.
5.3.5 mctrl
Usage: mctrl
Show all serial ports mode and related information.
Usage: mctrl [nn|all]
Set the “nn”
th
or all serial ports as the control mode.
Usage: mctrl [nn|all] idleto [] guardt [] hangchr []
Set the “nn”
th
or all serial ports data idle timeout, guard time and hang character.
5.3.6 mdata
Usage: mdata
Show all serial ports mode and related information.
Usage: mdata [nn|all]
Set the “nn”
th
or all serial ports as the data mode.
Usage: mdata [nn|all] protocol [TCP|UDP]
Set the “nn”
th
or all serial ports’ transmit protocol as TCP or UDP.
Usage: mdata [nn|all] idleto [] lsport [] atport []
Set the “nn”
th
or all serial ports data idle timeout, listen port, and AT command
port.
Usage: mdata [nn|all] respto [] framebk []
Set the “nn”
th
or all serial ports response timeout and frame break.
Usage: mdata [nn|all] peernum [1-16] peer [d.d.d.d:d] ...
Set the peer IP address and port for receive data.
Usage: mdata [nn|all] bysize [] bytime [] bychar [NULL|] bychartimeout [ON|OFF]
Set datapackage as size(bytes) or time(ms) or character(HEX) and
charactertime out.
Value 0 : None Setting.
Usage: mdata [nn|all] autopeerip [ON|OFF]
Set auto connect to peer ip as on or off.
5.3.7 net
Usage: net [1|2]
Show the first or second Ethernet port status and information.
Usage: net [1|2] mode [static|dhcp|boot|all]
Set the network operating mode.
Usage: net [1|2] ip [d.d.d.d] netmask [d.d.d.d] gw [d.d.d.d]
Set IP address, subnet mask, and default gateway.
Usage: net [1|2] dns [auto|specific]
Enable/Disable DNS.
Usage: net [1|2] dns1 [d.d.d.d]
Set network DNS1.