Advantech UNO-2372G - Default Chapter; Table of Contents

xi UNO-2372G User Manual
Contents
Chapter 1 Overview...............................................1
1.1 Introduction ............................................................................................... 2
1.2 Safety Precautions .................................................................................... 2
1.3 Accessories............................................................................................... 3
1.4 Hardware Specifications ........................................................................... 3
Chapter 2 Hardware Functionality.......................5
2.1 Introduction ............................................................................................... 6
Figure 2.1 Front panel of the UNO-2372G single-stack model.... 6
Figure 2.2 Rear panel of the UNO-2372G single-stack model .... 6
Figure 2.3 Front panel of the UNO-2372G double-stack model .. 6
Figure 2.4 Rear panel of the UNO-2372G double-stack model... 6
2.2 Serial Communication Ports...................................................................... 7
2.2.1 COM Port Interfaces (COM1, COM2, COM3, COM4) .................. 7
2.3 LAN: Ethernet Connector .......................................................................... 7
2.4 Power Connector ...................................................................................... 7
2.5 USB Connector ......................................................................................... 7
2.6 RTC Battery .............................................................................................. 7
2.7 Power Button/Power Management ........................................................... 7
2.8 Reset Button ............................................................................................. 7
2.9 PCI Express Mini Card Socket.................................................................. 8
Chapter 3 Initial Setup ..........................................9
3.1 Chassis Grounding.................................................................................. 10
Figure 3.1 Chassis grounding connection ................................. 10
3.2 Connecting Power................................................................................... 10
3.3 Opening/Closing the Rear Cover ............................................................ 10
3.4 Installing a Hard Disk .............................................................................. 12
3.5 Installing a Second Stack Extension Kit (UNO-2372G-EKAE)................ 18
Appendix A System Settings/Pin Assignments ..19
A.1 CN10 Internal GPIO Pin Header ............................................................. 20
Table A.1: CN10 Internal GPIO Pin Header .............................. 20
A.2 Board Connectors and Switches............................................................. 21
Figure A.1 Connector and jumper locations (front) .................... 21
Table A.2: Connectors and Jumpers ......................................... 21
A.3 Power Connector (PWR)......................................................................... 22
Table A.3: Power Connector Pin Assignments .......................... 22
A.4 DP Connector.......................................................................................... 22
Table A.4: DisplayPort Adaptor Cable Pin Assignment ............. 22
A.5 USB 3.0................................................................................................... 23
Table A.5: USB 3.0 Connector Pin Assignments....................... 23
A.6 HDMI Display Connector......................................................................... 23
Table A.6: HDMI Display Connector .......................................... 23
A.7 COM1/COM2/COM3/COM4 RS232/422/485 Connector ........................ 24
A.8 Mini PCIE Slot (MINI PCIE)..................................................................... 25
A.9 LAN RJ45 Connector .............................................................................. 26
A.10 Screw Type and Quantity for Mount Module........................................... 27
A.11 Modify Serial Port Mode.......................................................................... 27