Section II – Product Use
28
defibrillation shock button, a defibrillation shock will not be applied.
Without a moment’s hesitation, move on to the CPR procedure.
Lamps to indicate the operation state: The attachment of the
electrode pads ( ) and the electrocardiogram analysis lamp
( ) are lit.
10. Cardiopulmonary resuscitation should be performed.
10-1. Cardiopulmonary resuscitation should be performed without delay
after a defibrillation shock is delivered.
Voice prompt: “Apply pressure to the chest”, (CPR Beep) 30 chest
compressions, 2 rescue breaths (Whoo~Whoo~)
Lamps to indicate the operation state: The attachment of electrode
pads( ) and the electrocardiogram analysis lamp ( )are on,
and cardiopulmonary resuscitation lamp ( ) flashes.
10-2. An electrocardiogram of the patient is not analyzed while the
cardiopulmonary resuscitation is being performed.
If five cycles of the cardiopulmonary resuscitation guide are finished,
HeartPlus™ automatically will start the electrocardiogram analysis
again and the electrocardiogram data will be stored automatically.
10-3. Continue to perform the cardiopulmonary resuscitation until
emergency personnel arrive.
To Next Page
Loading...
