Startup
Hold down the “Power / Record” button for about 5 sec to start the
Wi-Fi based remote control.
A
fter startup, the screen will display the battery icon “ ”; if the
battery icon is empty, it indicates that the battery level is low and
charging is needed; please connect the USB power supply to the
USB port of the remote control for charging.
Pairing
Please carry out pairing before enabling the functions of the remote
control. Steps for pairing between the Wi-Fi based remote control and
the camera are stated as follows:
1. Turn on the camera and enable the Wi-Fi function;
2. First, press and hold the “Stop” Button of the Wi-Fi remote control;
then, hold down the “Power / Record” record for about 5 sec to
start
the remote control. The red power indicator will stay on and
the screen will display the battery icon “ ”;
3.
Hold down the “Power/Record” button and the “Stop” button, and
do not release these two buttons until the following icon of “WAIT
CAMERA PBC” appears.
To Next Page
Loading...
