- 31 / 50 - BN 09 2671/01/01
We can distinguish 2 scenarios:
or
In the second case, you must start again.
For the user level, apply the same procedure.
6.7.3.2 System setup
With the “supervisor” password, you have access to the following setup:
Battery selection: to select battery type, number of cells etc…
Nominal settings: to select mains, floating or high rate voltages, limit currents etc…
Meter selection: to select °C or °F.
High rate options: to allow manual high rate charge, activate the password protection etc…
Commissioning options:
to allow manual, activate password, select commissioning parameters.
Manual adjustment: to switch the rectifier in the power supply mode.
Battery test options: to select battery test parameters.
LVD function: to select Low Voltage Disconnect parameters.
Temperature compensation: to implement the battery voltage temperature compensation (option).
Communication options: to select serial communication parameters.
Charge protections: to set battery charge limits.
“User” and “supervisor” passwords setting: to change “user” or “supervisor” passwords.
Output cable drop compensation
USER LEVEL
Next Change Exit
PASSWORD CHANGED
NOT THE SAME
To Next Page
Loading...
