BN 09 2671/01/01 - 32 / 50 -
6.7.3.3 Alarms and events setup
The alarms setup menus are available with the “user” password and enable to set up the thresholds and the time-
delay of the accessible alarms.
The "supervisor" password enables to set up all parameters of the accessible alarms and events.
Alarms list:
High mains voltage alarm parameters.
Low mains voltage alarm parameters.
Charge fault alarm parameters.
High battery voltage alarm parameters.
Low battery voltage alarm parameters.
High DC voltage alarm parameters.
Low DC voltage alarm parameters.
Ground fault + alarm parameters.
Ground fault – alarm parameters.
Charger current limit alarm parameters.
Battery current limit alarm parameters.
High charger current alarm parameters.
High battery current alarm parameters.
High temperature alarm parameters.
Temperature sensor error alarm parameters.
Internal communication error alarm parameters.
Battery test failed alarm parameters.
Battery test abort alarm parameters.
High battery temperature alarm parameters.
Long charge time alarm parameters.
No power supply voltage alarm parameters.
Battery operation alarm parameters.
Battery symmetry alarm parameters.
Service alarms parameters (if applicable and activated at factory).
Procedure to activate an alarm which is disabled :
FLOATING CHARGE
Monit Confg Cmnd
SETUP
Next Enter Exit
Password: 1111
nter
SYSTEM SETUP
Next Enter Exit
ALARM SETUP
Next Enter Exit
Starting from the main menu, select ‘Confg’.
Select ‘Next’ until the following menu is displayed.
Select ‘Enter’.
A Supervisor or User level password is required to continue.
With the right pointing arrow '' the digit position can be selected
and with the arrow up '' an alphanumeric character between 0 and
9 or between A and Z can be set. If all four characters are set, press
‘Ente
’.
Select ‘Next’ until the menu ‘Alarm setup’ is displayed,
then select ‘Enter’
To Next Page
Loading...
