Need help?Do you have a question about the AEM CD-7 and is the answer not in the manual?
Explains standard CAN bus connection methods, including typical setups.
Describes how to use flying lead connections for inputs like page up and beacon.
Covers the setup and configuration for the secondary CAN bus.
Details custom harness connections for third-party CAN devices.
Highlights the features and capabilities of the Vehicle Dynamics Module (VDM).
Steps to configure the dash for GPS-based lap timing features.
Explains how to calibrate various channels like speed, fuel level, and throttle position.
How to configure output parameters within the Setup Editor.
Methods for configuring when data logging starts and stops based on input conditions.
Detailed guide on creating and configuring output parameters in the Setup Editor.
In-depth explanation of the CAN Receive tab for CAN message definition.
Setting up the shift lights and their associated alarm outputs.
Configuring warning lights based on alarm outputs.
To Next Page
General
