5
Setting the BMS 1 parameters ........................................................ p.21
Enable change over and on/o by supervisor ......................... p.21
Sets the BMS2 parameters ............................................................... p.21
Enables system on/o from digital input (ID17) ...................... p.21
Setting thermostat regulation ........................................................ p.22
Sets the logic for the setpoint and dierential in cooling
mode ........................................................................................................ p.22
Sets the logic for the setpoint and dierential in heating
mode ........................................................................................................ p.22
Climatic curve conguration in cooling mode ......................... p.22
Climatic curve conguration in heating mode ........................ p.22
Total recovery conguration ........................................................... p.23
Anti-freeze alarm conguration ..................................................... p.23
Managing the pumps ........................................................................ p.23
Congure anti-freeze management via the pump ................. p.23
Conguration of the anti-freeze alarm on the total
recovery ................................................................................................. p.23
Congure fans at low temperatures ............................................. p.24
Sets pump start-up for anti-freeze ................................................ p.24
Multi-function input conguration (U10) .................................. p.24
Conguration of power limitation for input (U10) .................. p.24
Conguration of the NTC signal for input (U10) ...................... p.24
Conguration of variable setpoint for input (U10) ................. p.25
Congure night mode control ....................................................... p.25
Conguration of the supplementary electric heaters ........... p.25
Sets the boiler as a replacement .................................................... p.25
Conguration of heater integration or replacement ............. p.25
Compressor hour counter monitor ............................................... p.26
Compressor start-up monitor ......................................................... p.26
Conguration of the fan speed ...................................................... p.26
Congure Master Slave ..................................................................... p.26
Conguration of the fan speed in free cooling ........................ p.26
Free cooling conguration (yield control).................................. p.26
Glycol water management .............................................................. p.27
VPF management (general parameters) ..................................... p.27
VPF management (Bypass 1 parameters) ................................... p.27
VPF management (Bypass 2 parameters) ................................... p.27
Unit information monitor ................................................................. p.27
Sets the interface language............................................................. p.27
Conguration of the units of measure ........................................ p.28
Congures the installer menu password .................................... p.28
9. List of alarms ...................................................................................... p.29