17
REPLACING THE REMOTE CONTROL’S BATTERIES
To replace the batteries of the infra red remote control
proceed as follows:
1. Open the battery cover by sliding it in the direction
of the arrow.
2. Remove the old batteries.
3. Insert two new 1.5V alkaline high performance
batteries, type LR03 (AAA), taking care not to reverse
the polarity.
4. Close the battery cover.
• NOTE:
• When batteries are replaced use new batteries of
the recommended type.
• Remove the batteries if the remote control is not
used for extended periods.
• The remote control can emit a signal up to a
maximum distance of 8 metres.
• The unit can be affected by signals transmitted
by remote controls for televisions, video
recorders, or other devices used in the same
room.
To Next Page
Loading...
