AGFA ADC Solo - Scan Unit; Transport Unit

Maintenance
DD+DIS013.02E
Section 12 / 8 ADC Solo Edition 1, Revision 10
(Type 5155 / 100/200)
3.6 Scan Unit
• Soft cloth
• ADC Cleaner
(if not available, use water)
• Allen key 3 mm
Scan rollers
(1) Remove the transport unit.
(see section 6.5)
(2) Clean all scan rollers (only with
a soft cloth and ADC Cleaner).
The scan rollers have to be
cleaned in place and must not be
removed. To move the scan rollers
just turn the drive of the slow scan
motor manually C.
Discharge
brush
(3) Check the discharge brush A
for visible wear and heavy dirt
– clean by hand or replace B, if
necessary.
B
A
A
C
Figure 5
3.7 Transport Unit
• Soft cloth
• ADC Cleaner
(if not available, use water)
• Suction cups
(CM+9.5145.6550.0)
Filter
(1) Pull the hoses off the filter
(2) Unscrew the filter spot A
(3) Shake the micro-filter B and
blow it clean.
A
B
Figure 6