36
4454C EN 2013-05-14The user interface
CR 35-X DIGITIZER
Audio signals
The CR 35-X gives status information via beeps. The length of the beep
indicates the response of the system to a key command.
• A short beep means that CR 35-X has accepted the key command and is starting
the operation.
• A long beep means that you have pressed a non-active key or that the CR 35-X
has rejected the key command.
• An interval beep accompanies an error, locked or warning message. Refer to
‘Troubleshooting checklist’ on page 65.
To Next Page
Loading...
