Automatically turning the DR Detector to sleep
The DR Detector can be configured to switch to standby (sleep) automatically
after not being used for a specific time.
New exposures can be made. After selecting an exposure on the NX
workstation, there will be a short delay until the DR Detector becomes ready
for exposure.
Automatically turning off DR Detector
The DR Detector can be configured to switch off automatically after not being
used for a specific time.
For making new exposures, the DR Detector must be started again using the
power button.
80 | DR 14s | Getting started
0350B EN 20190319 1349 *
To Next Page
Loading...
