Options 6
Advanced Operation 83
To set the LAN address at the keyboard
1 Press [Options]. Scroll to Communications and press [Enter].
2 Scroll to IP. Enter the numbers of the HS IP address,
separated by dots, and press [Enter]. A message tells you
to power cycle the instrument. Do not power cycle yet.
Press [Clear].
3 Scroll to GW. Enter the Gateway number and press [Enter].
A message tells you to power cycle the instrument. Do not
power cycle yet. Press [Clear].
4 Scroll to SM and press [Mode/Type]. Scroll to the
appropriate subnet mask from the list given and press
[Enter]. A message tells you to power cycle the instrument.
Do not power cycle yet. Press [Clear].
5 Scroll to Reboot instrument. Press [On/Yes] and [On/Yes] to
power cycle the instrument and apply the LAN setpoints.
To use a DHCP server
Note that DHCP is not supported by all Agilent data
systems. Most data systems instead require a fixed address.
By using the HS MAC address, however, you can also use
DHCP to assign a host name for the HS, and use this host
name to configure the HS in the data system.
1 Press [Options]. Scroll to Communications and press [Enter].
2 Scroll to Enable DHCP and press [On/Yes]. When prompted,
turn the instrument off and then on again.
To Next Page
Loading...
