22 7820A GC Installation Manual
7820A GC Installation Guide
The installation requires that you connect directly to the
GC using this address. However, after installation you
should change the GC IP address or set it to use DHCP.
1 If needed, install the PC.
2 Record the PC's current LAN address (either the IP
address, subnet mask, and gateway; or that the PC uses
DHCP).
3 Set the PC IP address to 192.168.0.1 and the subnet
mask to 255.255.255.0.
• See your Windows
® help for instructions for setting
the PC IP address. You may need administrator
privileges on the PC.
4 Open a command prompt in Windows. Type ping
192.168.0.26, then press Enter. The GC should respond.
See Figure 11.
• For help in using the ping command, see Windows
help.
• If ping fails, use the scroll keys to view the current
GC IP address on the GC display. If needed, change
the PC IP address or reset the IP address in the GC
(see the Operating Guide.)
To Next Page
Loading...
Need help?
General
