7820A GC Installation Guide
7820A GC Installation Manual 25
Run the Installation Wizard
1 When run for the first time, the Instrument Utility will
open to the Configure Instruments window.
2 Select Instrument Type Agilent 7820. The default IP
address (192.168.0.26) displays. Click Add Instrument to
connect to the GC. Close the Configuration window.
(If the Instrument Utility was already installed on the
PC, open it and go to Configuration > Instruments, then
select Add to My Instruments. From the Instrument Type
drop-down list, select GC type Agilent 7820, then enter
GC IP address 192.168.0.26. Click Add Instrument.)
3 In the left hand pane, click Tests.
4 Select your detector type from the Module View tab.
To Next Page
Loading...
Need help?
General
