aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa
Security Menu
Function Group
SYSTEM
Menu Map
8
Description
This softkey accesses the security function softkeys.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Blank Display
Turns o the swept signal generator's data display,
active entry, and message line areas.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Clear Memory
Writes alternating ones and zeros over all swept
signal generator state functions and save/recall
registers a selectable number of times, then returns
the swept signal generator to the factory-preset
state of operation.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Save Lock
Disables the save function.
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Zero Freq
Displays zeros for all accessible frequency
information.
The features listed above together with the softkeys
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Freq Offset
and
NNNNNNNNNNNNNNNNNNNNNNNNNNNNN
Freq Mult
provide the swept signal generator with security
controls for a variety of situations. The lo cal lo c
kout (LLO)
programming command adds security when the swept signal
generator is used in an ATE environment. A security calibration
constant that can b e accessed through the service adjustmen
t menu
(requires a password for access) is available also. Refer to the
Agilent
Technologies 8360 B-Series Swept Signal Generator/8360 L-Series
Swept CW Generator Service Guide
for information on calibration
constants.
See Also
Softkeys listed ab ove.
\Using the SecurityFeatures" in Chapter 1
S-58 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
