20 G7200-90210 (Rev. A) MassHunter Workstation Quick Start Guide
Elements 4 The list of masses and elements that will be monitored is displayed. The
information in this list is based on the sample and regulation selected
above. Review the element information and make any changes as follows:
a Right- click on the element of interest in the Element List Information.
b Select one of the following options from the shortcut menu:
• Add - see Step 4c below
• Delete - removes the selected mass from the list
• Edit - see Step 4c below
c If you are adding or editing an element, enter the following information
on the Add (or Edit) Elements dialog box, then click OK.
• Mass
• Element Name
• Integration time (sec/Point)
• Tune step number
d (optional) Click the Edit/View Equation button to view or edit an
interference correction equation. See online help for more information.
e Click the Next> button.
Finish 5 Review the method information, then click the Finish button.
Tip You can edit the method later by selecting Edit Entire Method from the
Methods menu and marking the parts of the method to edit, or from the menus
items shown in the previous section.
To Next Page
Loading...
Need help?
General