Agilent Technologies E3647A - Page 8

8
The Rear Panel at a Glance
Use the front-panel key to:
• Select the GPIB or RS-232 interface (see chapter 3).
• Set the GPIB address (see chapter 3).
• Set the RS-232 baud rate and parity (see chapter 3).
1 AC inlet
2 Power-line fuse-holder assembly
3 Power-line module
4
Output 1 Rear output terminals
5
Output 2 Rear output terminals
6 GPIB (IEEE-488) interface connector
7 RS-232 interface connector
I/O
Config