Chapter 4 Remote Interface Reference
System-Related Commands
96
*RST
Reset the power supply to its power-on state. The table below shows the state of the
power supply after a RESET from the Recall menu or *RST command from the
remote interface.
Note: The voltage and current step sizes listed above are typical value.
Command E3646A
state
E3647A
state
E3648A
state
E3649A
state
CURR
3 A0.8 A5 A1.4 A
CURR:STEP
0.052 mA 0.014 mA 0.095 mA 0.027 mA
CURR:TRIG
3 A0.8 A5 A1.4 A
DISP
ON
OUTP
OFF
OUTP:REL
OFF
TRIG:DEL
0
TRIG:SOUR
BUS
VOLT
0 V
VOLT:STEP
0.35 mV 1.14 mV 0.38 mV 1.14 mV
VOLT:TRIG
0 V
VOLT:PROT
22.0 V 66.0 V 22.0 V 66.0 V
VOLT:PROT:STAT
ON
VOLT:RANG
P8V (Low) P35V (Low) P8V (Low) P35V (Low)
To Next Page
Loading...
