Chapter 6 6-93
Front-Panel Key Reference
System (Local)
Pressing Preset (User) sets the analyzer to the settings
defined by the
Save User Preset key. Refer to “Preset” in
this chapter for more information. Key Access:
System,
Power On/Preset
Save User
Preset Saves the active state of the analyzer into the User
Preset register for recall on
Preset if Save (User) is
selected. Refer to “Preset” in this chapter for more
information. Key Access:
System, Power On/Preset
Time/Date Accesses the following Time/Date menu keys used to set and display the
real-time clock:
Time/Date
On Off Turns the display of the real-time clock on or off.
Key Access:
System, Time/Date
Date Format
MDY DMY Changes the display of the date from a month-day-year
format to a day-month-year format. Key Access:
System, Time/Date
Set Time Allows you to set the time of the real-time clock. Enter
the time in 24 hour HHMMSS format, using the
numeric keypad and pressing
Enter. Valid hour (HH)
values are from 00 to 23. Valid minute (MM) and
second (SS) values are from 00 to 59.
Key Access:
System, Time/Date
Set Date Allows you to set the date of the real-time clock. Enter
the date in the YYYYMMDD format using the numeric
keypad and press
Enter. Valid year (YYYY) values are
0000 through 9999. Valid month (MM) values are from
01 to 12, and valid day values are from 01 to 31.
Key Access:
System, Time/Date
Alignments Accesses the following Alignments menu keys which align the internal
circuitry of the analyzer, load default values for the alignment system,
and adjust the 10 MHz reference.
Auto Align Accesses the Auto Align menu keys. Selecting All turns
on the automatic alignment of all measurement
systems.
All but RF turns on the automatic alignment of
all measurement systems except the RF section.
(Eliminating automatic alignment of the RF prevents
changes in the input impedance between sweeps, which
could cause input device instability.)
Off turns off
automatic alignment. When
Auto Align, All is selected,
“
AA” appears along the left edge of the display. When
Auto Align, All but RF is selected, “AB” appears.
Key Access:
System, Alignments
To Next Page
Loading...
Need help?
General
