50 Chapter 2
Instrument Functions: A - L
AMPLITUDE / Y Scale
Instrument Functions: A - L
2.1.11.2 Antenna, Cable, Other, and User Keys
Pressing
Antenna, Cable, Other, or User accesses the Correction menu for that type of
correction data. These 4 keys display the status of correction sets. If the key indicates
On,
then amplitude corrections for this type have been enabled. To perform the corrections,
both this key and
Apply Corrections must indicate Yes. The status is toggled in the
correction set menu located under
Correction.
Key Path:
AMPLITUDE / Y Scale, More, Corrections
Remote Command:
There is no remote command for this key.
2.1.11.2.1 Correction
Turns the amplitude correction function on or off for the specific set of correction data. The
corrections state must be set to
On for the correction to be applied.
NOTE Antenna, Cable, and Other correction factors are generally entered as positive
values. This indicates a loss in the external device.
User correction factors are
typically entered as negative values which indicate a gain in the external
device.
Key Path:
AMPLITUDE / Y Scale, More, Corrections, Antenna (Cable, Other, or User)
State Saved: Saved in Instrument State
Factory Preset: No
Remote Command:
[:SENSe]:CORRection:CSET[1]|2|3|4[:STATe] OFF|ON|0|1
[:SENSe]:CORRection:CSET[1]|2|3|4[:STATe]?
Remote Command Notes: [:SENSe]:CORRection:CSET:ALL[:STATe] must be set to on
for this command to function.
CSET number equivalents to front-panel access definitions are as follows:
CSET or CSET1 is Antenna
CSET2 is Cable
CSET3 is Other
CSET4 is User
Example: CORR:CSET2 ON
CORR:CSET2?
To Next Page
Loading...
Need help?
General
