Agilent Technologies E5515C

To Next Page

To Previous Page

46 Chapter 2

cdma2000/IS-2000 Mobile Test Application

How Do I Change Cell Information?

2. Set an access parameter.

1. Turn the knob to highlight a parameter and then press the knob.

2. Enter a value or selection and press the knob.

3. Press the Close Menu (

F6) key.

深圳德标仪器 135-1095-0799

Main Page

Table of Contents15
AMPS/136 Mobile Test Application19
How Do I Make Measurements on a Mobile20
Establish a Call20
Select Measurements21
How Do I Change Measurement Setup22
Select a Measurement22
Set up the Measurement23
How Do I Turn off a Measurement24
How Do I Change Call Parameters25
How Do I Change the MS TX Level26
Change the Digital MS TX Level Immediately26
Change the MS TX Level During a Handoff27
How Do I Perform a Handoff28
How Do I Configure the Test Set for My Test System29
Configure Instrument Information and Setup29
Set Amplitude Offsets30
Check the Message Log31
How Do I End a Call32
Cdma2000/Is-2000 Mobile Test Application33
How Do I Make Measurements on a Mobile34
Establish a Call34
Select Measurements35
How Do I View a Graphical Measurement36
How Do I Change the Measurement Setup37
Select a Measurement37
Set up the Measurement38
How Do I Turn off a Measurement39
How Do I Set up a Call40
How Do I Change Call Parameters42
How Do I Change Cell Information43
Set Cell Parameters43
Select the Cell Parameters Menu43
Set a Cell Parameter44
Set Access Parameters45
Select the Access Parameters Menu45
Set an Access Parameter46
Set Registration Parameters47
Select the Registration Parameters Menu47
Set a Registration Parameter48
How Do I Change Code Channel Levels49
How Do I Perform a Handoff50
How Do I Configure the Test Set for My Test System51
Configure Instrument Information and Setup51
Set Amplitude Offsets52
Check Message Log53
How Do I End a Call54
GPRS Mobile Test Application55
How Do I Make Measurements on a Mobile56
Establish a Data Connection56
Select Measurements57
How Do I Change Measurement Setup58
Select a Measurement58
Set up the Measurement59
How Do I Turn off a Measurement60
How Do I Change Call Parameters61
How Do I Change Cell Parameters62
Select the Cell Parameters Menu62
Set a Cell Parameter63
How Do I Perform a Handover64
How Do I Change the MS TX Level65
Change the MS TX Level Immediately65
Change the MS TX Level During a Handover66
How Do I Configure the Test Set for My Test System67
Configure Instrument Information and Setup67
Set Amplitude Offsets68
Check the Message Log69
How Do I End the Data Connection70
GSM Mobile Test Application71
How Do I Make Measurements on a Mobile72
Establish a Call72
Select Measurements73
How Do I Change a Measurement's Setup74
Select a Measurement74
Set up the Measurement75
How Do I Turn off a Measurement76
How Do I Change Cell Parameters77
Select the Cell Parameters Menu77
Set a Cell Parameter78
How Do I Change Call Parameters79
How Do I Configure the Test Set for My Test System80
Configure Instrument Information and Setup80
Set Amplitude Offsets81
Check the Message Log82
How Do I End a Call83
GSM_AMPS/136 Fast Switch85
How Do I Switch Formats86
Choose a Format86
Switch Formats87
Switching Test Applications89
How Do Switch Test Applications90
Choose a Test Application90
Switch Test Applications91

Table of Contents

Related product manuals