54
S:\Hp8960\Generic Documents\Manual Operation Getting Started Guide\Pi_manual operation getting started guide\chapters\cdma2000_gen_op_overview_setup_call.fm
How Do I Set Up a Call?
How Do I Set Up an IS-95 Call?
1. Press the CALL SETUP key.
2. Press the Operating Mode (
F1) key and set the operating mode to Active Cell.
3. Press the System Type (
F2) key and select IS-95.
4. Press the Cell Band (
F8) key and select the band in which you would like to bring
up the call.
5. Press the Channel (
F9) key and set the RF channel number.
6. Press the Protocol Rev (
F10) key and set the protocol revision supported by the
mobile station.
7. Press the Service Option (
F12) key and select a service option for the call.
8. Check the rest of the Call Parms settings by pressing the
More key to display the 2
of 3 and 3 of 3 menus.
9. You may need to change cell settings such as SID (System Identification) to allow
the mobile station to find service. See “How Do I Change Cell Information?” on
page 57.
10.Turn on power to the mobile station and wait for an indication that it has found
service.
1
8
4
5
2
1
3
6
7
1
To Next Page
Loading...
Need help?
General
