Agilent 1200 Preparative Pump User Manual 37
Installing the Pump
3
Installing the Preparative Pump
1 Place the module on the bench in a horizontal position.
2 Ensure the power switch on the front of the preparative pump is OFF
(switch stands out).
3 At the rear of the preparative pump move the security lever to its maximum
right position.
Figure 7 Front View of the Preparative Pump
"Defective on arrival" problems
If there are signs of damage, please do not attempt to install the module. Inspection by
Agilent is required to evaluate if the instrument is in good condition or damaged.
➔ Notify your Agilent sales and service office about the damage.
➔ An Agilent service representative will inspect the instrument at your site and
initiate appropriate actions.
HZg^VacjbWZg
HiVijhaVbe
EdlZghl^iX]
To Next Page
Loading...
Need help?
General
