Using Your GTA
36 Agilent Graphite Tube Atomizer GTA 120 User’s Guide
The Optional GTA Viewing/Fume Extraction Accessory
If you are using the GTA viewing/fume extraction accessory, you
should install it now. Refer to Section 5 for installation instructions.
Installing the Programmable Sample Dispenser (PSD)
To install the PSD, follow the instructions in your PSD User’s Guide.
Graphite Tubes and Platforms
After setting up your GTA (and PSD), you can insert a graphite tube
and start your analytical run according to your instrument operation
manual. This section describes the types of tubes and platforms
available and how to install and remove them.
WARNING
Hot Surface
Parts of the furnace become very hot during use. To prevent burns, ALWAYS
allow the furnace to cool before touching.
Types of Available Graphite Tubes
Description Part number Picture
Omega platform tube, pyrolytically
coated (Packet of 10)
6310003700
Partitioned tube, pyrolytically coated
(Packet of 10)
6310001200
Plateau, pyrolytically coated (Packet of
10) required for use with pyrolytic
graphite platforms
6310001100
To Next Page
Loading...
