iii
Legal Information
Certification
Agilent Technologies certifies that this product met its published specifications at
the time of shipment from the factory. Agilent Technologies further certifies that its
calibration measurements are traceable to the United States National Institute of
Standards and Technology, to the extent allowed by the Institute’s calibration
facility, and to the calibration facilities of other International Standards Organization
members.
Safety Symbols
The following symbols on the Test Set and in the documentation indicate
precautions which must be taken to maintain safe operation of the Test Set.
This is the ‘Caution - Refer to Instruction
Documentation’ Symbol. The product is marked with
this symbol when it is necessary for the user to refer to
the instructions in the supplied documentation.
Alternating current (AC)
This symbol indicates the position of the operating
switch for ‘Stand-by’ mode. Note, the Test Set is NOT
isolated from the mains when the switch is in this
position. To isolate the Test Set, the mains coupler
(mains input cord) should be removed from the power
supply.
N4010-90086.book Page iii Monday, November 18, 2013 9:20 AM
To Next Page
Loading...
Need help?
General
