Making Your First Measurements
Running a SCPI Confidence Check
Chapter 2 27
Running a SCPI Confidence Check
If you have previously installed the Agilent I/O Libraries Suite software using the
procedure described in the N4010A CD-ROM Installation Guide, you can proceed
directly to Step 2.
Step 1. Install the Agilent I/O Libraries Suite software by following the instructions on the
N4010A CD-ROM or:
1. Insert the Agilent Automation-Ready into your CD drive and install using the
on-screen instructions.
If the CD does not auto-start, from your windows task bar select Start > Run. In
the field enter <CDdrive>:\autorun\auto.exe where <CD drive> is the
letter of your CD drive.
2. Close the Agilent IO libraries Suite 14.1 installation window.
3. Close the Agilent Connection Expert program.
4. You have completed Step 1 of the 3 Step process.
Step 2. Connecting the Test Set
Refer to “Connecting USB, GPIB or LAN” on page 18.
N4010-90086.book Page 27 Monday, November 18, 2013 9:20 AM
To Next Page
Loading...
